Wiper Motor Replacement Video Guide

Introduction

Windshield wipers are an essential safety feature that keep your视野清晰in inclement weather. When the wiper motor fails, it can be a major inconvenience and safety hazard. Replacing a wiper motor is not a difficult task, but it does require some basic mechanical skills. This step-by-step video tutorial will show you how to replace a wiper motor on a typical vehicle.

Materials Needed

Replacement wiper motor

Socket wrench set

Screwdriver

Pliers

Wire cutters

Electrical tape

Safety Precautions

Disconnect the negative battery terminal before starting any work.

Wear safety glasses and gloves.

Be careful not to cut yourself on the sharp edges of the wiper motor.

Instructions

1. Locate the Wiper Motor

The wiper motor is usually located underneath the windshield, behind the firewall. It is a small, black motor with a series of electrical connectors.

2. Disconnect the Electrical Connectors

Use a screwdriver to disconnect the electrical connectors from the wiper motor. There will typically be two or three connectors.

3. Remove the Bolts

Use a socket wrench to remove the bolts that hold the wiper motor in place. There will typically be three or four bolts.

4. Pull Out the Wiper Motor

Once the bolts are removed, you can pull the wiper motor straight out of the vehicle.

5. Install the New Wiper Motor

Insert the new wiper motor into the vehicle and align it with the mounting holes.

6. Tighten the Bolts

Use a socket wrench to tighten the bolts that hold the wiper motor in place.

7. Reconnect the Electrical Connectors

Use a screwdriver to reconnect the electrical connectors to the wiper motor.

8. Test the Wiper Motor

Reconnect the negative battery terminal and turn on the ignition. Test the wiper motor by turning the wipers on and off.

Conclusion

Replacing a wiper motor is a relatively simple task that can be completed in about an hour. By following these instructions, you can save yourself the cost of having a mechanic do the job.