18330991235

Special Wiper

Proton Saga-Iswara Car Wiper

1. IntroductionThe Proton Saga-Iswara is a subcompact car produced by the Malaysian automaker Proton from 1992 to 2003. It was based on the Proton Saga, which w...

Free Inquiry

24 hours free inquiry phone18330991235

  • Product Details

1. Introduction

The Proton Saga-Iswara is a subcompact car produced by the Malaysian automaker Proton from 1992 to 2003. It was based on the Proton Saga, which was itself based on the Mitsubishi Lancer Fiore. The Saga-Iswara was available as a four-door sedan and a five-door hatchback.

2. Windshield Wipers

The Proton Saga-Iswara was equipped with a single-speed windshield wiper system. The wipers were controlled by a stalk on the left-hand side of the steering column. The stalk had three positions: off, intermittent, and on.

3. Automatic Wiper Control

The Saga-Iswara was not available with automatic wiper control.

4. Wiper Blades

The Saga-Iswara used conventional wiper blades. The blades were made of a rubber compound and were attached to the wiper arms with a bayonet fitting.

5. Wiper Motor

The wiper motor was located under the dashboard on the passenger side of the car. The motor was connected to the wiper arms by a linkage.

6. Wiper Transmission

The wiper transmission was located on the firewall. The transmission was connected to the wiper motor by a shaft.

7. Troubleshooting

If the windshield wipers on your Proton Saga-Iswara are not working, there are a few things you can check:

 Wiper fuse: The wiper fuse is located in the fuse box under the dashboard. If the fuse is blown, replace it with a new one of the same amperage.
 Wiper switch: The wiper switch is located on the left-hand side of the steering column. If the switch is faulty, it will need to be replaced.
 Wiper motor: The wiper motor is located under the dashboard on the passenger side of the car. If the motor is faulty, it will need to be replaced.
 Wiper transmission: The wiper transmission is located on the firewall. If the transmission is faulty, it will need to be replaced.
 Wiper blades: If the wiper blades are worn or damaged, they will need to be replaced.

8. Replacement

If you need to replace the wiper motor, wiper transmission, or wiper blades on your Proton Saga-Iswara, you can follow these steps:

 Wiper motor:
    1. Disconnect the negative battery terminal.
    2. Remove the wiper arms from the windshield.
    3. Remove the bolts that hold the wiper motor in place.
    4. Disconnect the electrical connector from the wiper motor.
    5. Remove the wiper motor from the car.
    6. Install the new wiper motor in the reverse order of removal.
 Wiper transmission:
    1. Disconnect the negative battery terminal.
    2. Remove the wiper arms from the windshield.
    3. Remove the bolts that hold the wiper transmission in place.
    4. Disconnect the electrical connector from the wiper transmission.
    5. Remove the wiper transmission from the car.
    6. Install the new wiper transmission in the reverse order of removal.
 Wiper blades:
    1. Lift the wiper arm away from the windshield.
    2. Slide the old wiper blade off the wiper arm.
    3. Slide the new wiper blade onto the wiper arm.
    4. Lower the wiper arm back onto the windshield.

9. Conclusion

The Proton Saga-Iswara's windshield wiper system is a relatively simple and reliable system. With proper maintenance, the wipers should last for many years.