Replace Your Windshield Wiper Tank with Ease: A Guide for 2014 Fleetwood Bounder 35K

Serial Number: [Enter Serial Number]

Introduction

Maintaining a properly functioning windshield wiper tank is crucial for ensuring clear visibility and safe driving, especially during adverse weather conditions. This article will provide a comprehensive guide to replacing the windshield wiper tank in a 2014 Fleetwood Bounder 35K motorhome.

Materials Required

New windshield wiper tank (Fleetwood part number: 3305124100)

3/8-inch wrench or socket

Phillips screwdriver

Funnel

Wiper fluid

Step-by-Step Instructions

1. Safety First

Ensure the vehicle is parked on a level surface and the engine is turned off.

Disconnect the negative terminal of the battery to prevent electrical hazards.

2. Locate the Wiper Tank

Open the front hood of the Bounder.

Locate the windshield wiper tank, which is typically situated near the top of the firewall.

3. Disconnect the Wiper Motor

Using a 3/8-inch wrench or socket, loosen the two bolts that secure the wiper motor to the tank.

Carefully remove the wiper motor and place it aside.

4. Remove the Hoses

Disconnect the two hoses that connect the tank to the wiper motor and engine coolant system.

Have a funnel ready to catch any residual fluid.

5. Unmount the Tank

Use a Phillips screwdriver to remove the screws that secure the tank to the vehicle frame.

Carefully lift the tank out of its mounting location.

6. Install the New Tank

Position the new tank into the mounting location and secure it with the provided screws.

Reattach the hoses to the tank, ensuring they are properly connected.

7. Mount the Wiper Motor

Place the wiper motor onto the new tank and secure it with the two bolts.

8. Fill the Tank

Use a funnel to fill the new tank with wiper fluid.

Check the level window on the tank to ensure it is filled to the appropriate level.

9. Reconnect the Battery

Reconnect the negative terminal of the battery.

10. Test the System

Start the vehicle and activate the windshield wipers.

Ensure the wipers are functioning properly and there are no leaks.

Additional Tips

Use high-quality wiper fluid to prevent freezing and corrosion.

Inspect the wiper blades and hoses regularly for wear and tear.

Consider replacing both the tank and wiper blades at the same time to maximize wiper performance.

Conclusion

Replacing the windshield wiper tank in a 2014 Fleetwood Bounder 35K is a straightforward task that can be completed in under an hour with basic tools and materials. By following the steps outlined in this guide, you can ensure your bounder has a clean and clear windshield, providing you with a safe and enjoyable driving experience.