18330991235

wiper arm assembly for ford fusion 20092024-11-01 22:00:12

Serial Number: 123456789

Title: Wiper Arm Assembly Replacement for 2009 Ford Fusion: A Comprehensive Guide

Subtitle: Step-by-Step Instructions to Ensure Smooth Operation and Clear Visibility

Introduction:

The windshield wiper arm assembly plays a crucial role in keeping your driving vision clear during inclement weather. In the 2009 Ford Fusion, the wiper arm assembly consists of two arms, passenger side and driver side, that hold the wiper blades and allow them to move across the windshield. Over time, these arms can become worn, damaged, or loose, affecting the efficiency and safety of your windshield wipers. This comprehensive guide will provide detailed step-by-step instructions on how to replace the wiper arm assembly on your 2009 Ford Fusion, ensuring a seamless replacement process and optimal visibility.

Tools and Materials Required:

New wiper arm assembly (driver side and passenger side)

Socket wrench or ratchet

13mm socket

Torx T30 screwdriver

Phillips head screwdriver

Clean rags

Gloves

Safety Precautions:

Park the vehicle on a level surface and engage the parking brake.

Turn off the ignition and remove the keys.

Allow the engine to cool down to avoid burns.

Wear gloves to protect your hands from dirt and sharp edges.

Follow all instructions carefully and avoid making any modifications to the vehicle.

Step-by-Step Instructions:

1. Preparing the Work Area:

Locate the wiper assembly beneath the hood.

Lift the wiper arms away from the windshield.

Secure the wiper arms with a piece of tape or twine to prevent them from falling onto the windshield.

2. Removing the Driver Side Wiper Arm:

Use a 13mm socket to loosen the nut holding the wiper arm to the pivot shaft.

Carefully lift the wiper arm straight up to detach it from the shaft.

Inspect the condition of the pivot shaft and apply grease if necessary.

3. Installing the Driver Side Wiper Arm:

Align the new wiper arm with the pivot shaft.

Push the wiper arm onto the shaft until it fits securely.

Tighten the nut using the 13mm socket, ensuring it is snug but not overtightened.

4. Removing the Passenger Side Wiper Arm:

Use a Torx T30 screwdriver to remove the two screws that secure the plastic cover on the passenger side wiper pivot shaft.

Lift off the plastic cover and locate the nut beneath it.

Use a 13mm socket to loosen the nut and remove the wiper arm from the shaft.

5. Installing the Passenger Side Wiper Arm:

Position the new wiper arm on the pivot shaft.

Push down on the wiper arm to engage it with the shaft.

Replace the plastic cover and tighten the screws using the Torx T30 screwdriver.

6. Finalizing the Replacement:

Lower the wiper arms back onto the windshield.

Remove the tape or twine securing the wiper arms.

Check the operation of the wiper arms by turning on the ignition and activating the wipers.

Tips:

If the wiper arms are rusty or difficult to remove, apply penetrating oil to the nuts and bolts.

Clean the windshield thoroughly before operating the new wiper arms to remove any debris that could scratch the glass.

Replace the wiper blades regularly to maintain optimal visibility and extend the life of the wiper arm assembly.

Conclusion:

Replacing the wiper arm assembly on a 2009 Ford Fusion is a straightforward task that can be completed within an hour using the steps outlined in this guide. By following these instructions carefully, you can ensure that your windshield wipers operate smoothly and provide clear visibility during adverse weather conditions, enhancing your driving safety and comfort.