Marinco MRV Wiper Motor Wiring Diagram

Introduction

The Marinco MRV wiper motor is a high-quality, durable motor designed for use in marine applications. It is a 12-volt motor with a built-in circuit breaker, and it is capable of driving up to three wipers. The MRV wiper motor is easy to install and operate, and it comes with a complete wiring diagram.

Wiring Diagram

The Marinco MRV wiper motor wiring diagram is shown below.

[Image of Marinco MRV wiper motor wiring diagram]

Wire Colors

The wire colors used in the Marinco MRV wiper motor wiring diagram are as follows:

Black: Ground

Red: Power

Blue: Wiper motor high speed

Green: Wiper motor low speed

Connections

The Marinco MRV wiper motor is connected to the power source through the red wire. The black wire is connected to the ground. The blue and green wires are connected to the high speed and low speed terminals on the wiper motor, respectively.

Circuit Breaker

The Marinco MRV wiper motor has a built-in circuit breaker that protects the motor from damage in the event of a short circuit. The circuit breaker is located on the side of the motor, and it can be reset by pressing the button on the top of the circuit breaker.

Installation

The Marinco MRV wiper motor is easy to install. First, mount the motor to the boat using the provided mounting brackets. Next, connect the wires according to the wiring diagram. Finally, test the motor by turning it on and off.

Operation

The Marinco MRV wiper motor is operated by a switch that is mounted on the dashboard. The switch has three positions: off, low speed, and high speed. To turn the wipers on, simply turn the switch to the desired speed. To turn the wipers off, turn the switch to the off position.

Troubleshooting

If the Marinco MRV wiper motor is not working properly, there are a few things that you can check. First, check the power